A complete set of E-PROPS V20 range spinners is composed of the spinner, its mounting plate and the necessary screws.
These spinners are designed for the V20 range of tractor and pusher propellers (DURANDAL & EXCALIBUR).
They are made in carbon fabric + epoxy resin.
The E-Props spinners are ultra-light. Example : spinner diameter 250 mm with its mounting plate and screws = 465 g
Spinner diameter is depending on the engine cover of the aircraft.
The E-Props spinners exit in 15 diameters.
If you hesitate between two sizes, take the smaller, for a better air flow on the engine cover.
The interactive diagram below allows to visualize the different diameters =>
✗ INTERACTIVE DIAGRAM
Please note : the 210 mm diameter spinner do not fit on the 4-blade and 5-blade E-Props propellers.
The hubs of these models are too big for this diameter.
The E-Props spinners of the V20 range are mounted on a drilled plate positioned on the spacer.
This set is very light and extremely strong.
They are suitable for all configurations of E-PROPS V20 spacers.
The E-Props V20 range spinners are held on their plate by 9 M5 x 16 screws. Tightening torque = 5 N.m
E-PROPS has chosen screws with domed head, slotted, to allow dismantling the spinner with a simple coin (if no tools are available).
click on the video to see how to assemble the V20 spinners
==> Assembly instructions for V20 spinners : see page MANUALS
In some cases, in order to balance the spinner and plate assembly, one or more washers are glued into the spinner by E-PROPS.
Under no circumstances should they be removed or replaced, otherwise the balance of the spinner would no longer be assured and vibrations could occur.
On the spinner, a yellow sticker indicates : "Do not remove - balancing weight".
E-PROPS spinner V20 diameter 250 mm, length 309 mm, weight 465 g all inclusive (plate and screws)
To date, E-PROPS V20 spinners are available in carbon, bright polished, unpainted, gel-coat or varnished finishes.
It will be possible to offer painted spinners as soon as the new E-Props factory is completed.
The pilot can paint his spinner if he wishes.
To do so, the surface of the spinner must be deglazed, i.e. sanded very lightly (600 grit sandpaper) to create a good grip for the paint.
The recommended paint is a two-component polyurethane. A well sanded primer is necessary for a nice finish.
Be careful not to overload the spinner during the painting process.
It is necessary to keep a light hand and to distribute well the layers of primer and paint.
=> As of December 2019, E-PROPS has stopped manufacturing the V12 spinners (and mini spinners).
We have no more V12 spinners in stock.
They have been replaced by the V20 spinners.
This is an evolution of the range. The V20 spinners are faster to manufacture and are lighter than the V12 spinners. Their finish is also more aesthetic.
The E-PROPS PROPELLERS Company
195, Route de l'Aviation
ZI Aérodrome de Sisteron
04200 VAUMEILH - France
Phone : +33 4 92 34 00 00
Phone reception opened from Monday to Friday
From 10 to 12 a.m and 2 to 4 p.m The best way to reach us is by email : email@example.com