Blades protective tape - rolls
EUR
10.00€ VAT excl.
in stock: 204
Blade protection tape on roll (width 50 mm) - the different lengths: length : 40 cm length : 60 cm (+5.00€ VAT excl.) length : 80 cm (+10.00€ VAT excl.) length : 100 cm (+15.00€ VAT excl.) length : 120 cm (+20.00€ VAT excl.) length : 140 cm (+25.00€ VAT excl.) length : 160 cm (+30.00€ VAT excl.) length : 180 cm (+35.00€ VAT excl.) length : 200 cm (+40.00€ VAT excl.) length : 220 cm (+45.00€ VAT excl.) length : 240 cm (+50.00€ VAT excl.)
Rolls of leading edge protection tape, 50 mm wide and of various lengths (to be chosen)
This polyurethane protective tape is made from a very high performance elastomer that is resistant to erosion, abrasion, punctures, minor impact damage and tears. Its formula is also UV resistant. It is of interest on blades that are not equipped with metal leading edge protection.
This specific model of polyurethane protective tape is used on certified helicopter blades . Although it is applied to the blade, this protective tape does not impact aerodynamic performance (at least this is not measurable).
It is adhesive on one side, very easy to apply and change. It is transparent, it can be painted or applied on painted surfaces.
Very effective to protect from water and sand, to be used in special cases:
- paramotors: 'barefoot' flights at water or beach level
- seaplanes
- very long flights under heavy rain at high engine rpm
Thickness: 0.36 mm
Width: 50 mm
Each roll is delivered uncut
Easy to install. Thoroughly clean the blade before sticking the polyurethane tape.
To remove the leading edge protective tape, gently heat it with a hair dryer (not a heat gun which would be too hot).
As soon as the tape becomes a little soft, you can remove it by pulling it out, possibly by gently scraping it off with a wooden spatula.
Remove the glue by gently dabbing the glue with acetone (do not dip the blade in acetone).
Finally, clean the blade well to remove acetone residues.